Configuring Sole Parameters - Brocade Communications Systems RFS6000 System Reference Manual

5. The AP Information section displays the following information about APs:
AP MAC Lists the MAC Addresses of all APs which have been configured for RTLS.
Location: Displays the value of the X Coordinate for each AP. The X coordinate is relative to the origin point of 0,0 in the upper
X Coordinate left corner of the site map. This value is user configured and not detected by the switch. For information on how to
configure AP location information, see Chapter 5, Adding AP Location Information.
Location: Displays the value of the Y Coordinate for each AP. The Y coordinate is relative to the origin point of 0,0 in the upper
Y Coordinate left corner of the site map. This value is user configured and not detected by the switch. For information on how to
configure AP location information, see Chapter 5, Adding AP Location Information.
Location: Displays the value of the Z Coordinate for each AP. The Z coordinate is the height of the AP relative to the lowest point
Z Coordinate of the site. This value is user configured and not detected by the switch. For information on how to configure AP
location information, see Chapter 5, Adding AP Location Information.
Status Displays the status value for each AP.
Switch IP Displays the IP address of switch associated with each AP configured for RTLS.
11a Radio Displays the Index, MAC Address, Power and Channel information for the 802.11a radio on each AP.
11b Radio Displays the Index, MAC Address, Power and Channel information for the 802.11b radio on each AP.
6. Click the Apply button to save the changes made within this screen. Clicking Apply overwrites
7.
Adding AP Location Information
1. To add AP Location information for your site: Select Services > RTLS from the main menu tree.
2. Select the Site tab.
3. Click the Add button.

Configuring SOLE Parameters

To configure the switch's internal SOLE locationing engine:
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01
the previous configuration.
Click the Revert button to disregard any changes made within this screen and revert back to
the last saved configuration.
5
323