Brocade Communications Systems RFS6000 System Reference Manual page 126

4
2. Select an existing WLAN from those displayed within the Configuration tab and click the Edit
3. Select the VLAN radio button from the Configuration screen to change the VLAN designation for
4. Select the Dynamic Assignment checkbox for a user-based VLAN assignment with Radius for
5. Select the Assign Multiple VLAN(s) button to map a WLAN to more than one VLAN. This displays
6. Configure the Multiple VLAN Mapping for WLAN table as required to add or remove multiple
VLAN
User Limit
7.
8. Select a row from the Multiple VLAN Mapping table and click the Remove button to delete the
9. Refer to the Status field for the current state of the requests made from applet. This field
10. Click OK to use the changes to the running configuration and close the dialog.
11. Click Cancel to close the dialog without committing updates to the running configuration.
NOTE
In a cluster environment with multiple switches, ensure that the VLAN list is consistent across all
switches.
114
button.
A WLAN screen displays with the WLAN's existing configuration.
this WLAN.
By default, all WLANs are initially assigned to VLAN 1.
this WLAN.
the Multiple VLAN Mapping screen.
VLANS for the selected WLAN.
Multiple VLANs per WLAN are mapped (by default) to a regular VLAN and are not supported on
an adaptive AP. Refer to Editing the WLAN Configuration on page 4-109 to select and define an
independent VLAN for adaptive AP support.
Displays the VLANs currently mapped to the WLAN. By default, VLAN 1 is configured for any selected
WLAN.
Displays the user limit configured for the mapped VLAN. The maximum allowed user limit is 4096 per
VLAN.
Click the Insert button to add the VLAN using the criteria described above.
mapping of a VLAN to a WLAN.
displays error messages if something goes wrong in the transaction between the applet and
the switch.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01