Unauthorized Aps (Ap Reported) - Brocade Communications Systems RFS6000 System Reference Manual

6
2. Select the Authorized APs tab.
3. The Approved APs table displays the following information:
BSS MAC Address Displays the MAC Address of each approved AP. These MAC addresses are Access Points observed on the network
meeting the criteria (MAC and ESSIDs) of allowed APs.
Reporting AP Displays the numerical value assigned to the radio used with the specific device MAC Address and SSID listed for
this approved AP.
Channel Displays the channel the approved AP is currently transmitting on. If this device is operating on a channel not
frequently used within your network segment, perhaps the device is correctly defined as an approved AP.
Last Seen (In Seconds) Displays the time (in seconds) the approved AP was last seen on the network.
ESSID Displays the SSID of each approved AP.
Authorized/Ignored Aps Displays authorized APs.
4. The Number of Approved APs is simply the sum of all of approved Access Point MAC Addresses
5. Select the Display Adopted APs check box.
6. Click on the Export button to export the contents of the table to a Comma Separated Values file

Unauthorized APs (AP Reported)

Use the Unapproved APs (AP Reported) tab to review Access Points detected by associated switch
Access Port radios and are restricted from operation within the switch managed network. The
criteria for restriction was defined using the Security > Access Point Detection > Configuration
screen.
To view Access Port detected unapproved Access Points:
1. Select Security > Access Point Detection from the main menu tree.
336
detected.
(CSV).
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01