Brocade Communications Systems RFS6000 System Reference Manual page 235

To view existing Radio Configuration information:
1. Select Network > Access Port from the main menu tree.
Unadopted AP
Click the
Index Displays a numerical identifier used to associate a particular Access Port with a set of statistics and can help
differentiate the Access Port from other Access Ports with similar attributes.
MAC Address Displays the unique Hardware or Media Access Control (MAC) address for the Access Port. Access ports with dual
radios will have a unique MAC address for each radio. The MAC address is hard-coded at the factory and cannot be
modified.
Last Seen (In Seconds) Displays the time the Access Port was last seen (observed within the switch-managed network). This value is
expressed in seconds. Use this value to assess if the Access Port is no longer in communications with the switch.
Number of Unadopted Displays the total number of Access Ports (at the bottom of the screen) that have been recognized, but not adopted
APs by the switch.
2. Select an available index and click the Adopt button to display a screen wherein the properties
3. Click the Export button to export the contents of the table to a Comma Separated Values file
CAUTION
An Access Port is required to have a DHCP provided IP address before attempting layer 3
adoption, otherwise it will not work. Additionally, the Access Port must be able to find the IP
addresses of the switches on the network. To locate switch IP addresses on the network:
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01
tab.
The Unadopted AP tab displays the following information:
of a new radio can be added for adoption to the switch. When displayed, the screen prompts
for the MAC address and type of radio. Complete the fields and click the OK button to add the
radio.
(CSV).
4
223