NOTE
Configure the secondary NAC server for redundancy.
3. Clients not NAC authenticated use Radius for authentication. To configure the WLAN's Radius
4. Configure the NAC server's timeout and re-transmit settings. The timeout parameter
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01
a. Configure the NAC Server's IP address.
RF Switch(config-wireless) #wlan 1 nac-server primary 192.168.1.10
RF Switch(config-wireless) #
b. Configure the NAC Server's Radius Key.
RF Switch(config-wireless) #wlan 1 nac-server primary radius-key my-secret
RF Switch(config-wireless) #
c.
Configure the secondary NAC server's IP address.
RF Switch(config-wireless) #wlan 1 nac-server secondary 192.168.1.20
RF Switch(config-wireless) #
d. Configure the secondary NAC Server's Radius Key.
RF Switch(config-wireless) #wlan 1 nac-server secondary radius-key my secret-2
RF Switch(config-wireless) #
settings:
a. Configure the Radius server's IP address.
RF Switch(config-wireless) #wlan 1 radius-server primary 192.168.1.30
RF Switch(config-wireless) #
b. Configure the server's Radius Key
RF Switch(config-wireless) #wlan 1 radius-server primary radius-key my-rad-secret
RF Switch(config-wireless)#
c.
Configure the secondary Radius server's IP address.
RF Switch(config-wireless) #wlan 1 radius-server secondary 192.168.1.40
RF Switch(config-wireless) #
d. Configure the secondary server's Radius Key.
RF Switch (config-wireless) #wlan 1 radius-server secondary radius-key my-rad-secret-2
RF Switch (config-wireless) #
configures the duration for which the switch waits for a response from the Radius server before
attempting a retry. This is a global setting for both the primary and secondary server.
The re-transmit parameter defines the number of retries a switch attempts before
dis-associating
the client.
RF Switch(config-wireless) #wlan 1 nac-server timeout 30 retransmit 10
RF Switch(config-wireless) #
4
159