Brocade Communications Systems RFS6000 System Reference Manual page 56
Provides centralized wireless lan (wlan)
Hide thumbs
Also See for RFS6000:
- Cli reference manual (839 pages) ,
- System reference manual (574 pages)
Table of Contents
Advertisement
3
Apart from the sections mentioned above, it also displays the following status:
Redundancy State
Firmware
Management IP
Access Ports
Mobile Units
Up Time
1. Refer to the Alarms field for details of all the unacknowledged alarms generated during the
Severity
Last Occurrence
Message
# Occurrences
2. Refer to the Ports field for link, speed and duplex status of each physical port on the switch's
Name
Status
Speed
Duplex
3. The Environment section displays the CPU temperature. It displays the valid threshold range
44
Displays the Redundancy State of the switch. The status can be either Enabled or Disabled.
•
Enabled - Defined a green state.
•
Disabled - Defined by a yellow state.
Displays the Firmware version of the current software running on the wireless switch.
Displays the Management IP address of the switch.
Displays the total number of Access Ports adopted by the switch.
Displays the total number of Clients associated with the switch.
Displays the actual switch uptime. The
defined within the System Name field. Uptime is the cumulative time since the switch was
last rebooted or lost power.
past 48 hours. The alarms are classified as:
•
Critical — Denoted by a red indicator. These alarms warrant immediate attention.
•
Major — Denoted by a yellow indicator. These alarms warrant attention.
•
Others — Denoted by a blue indicator.
The alarms field also displays details (in a tabular format) of the 5 most recent
unacknowledged critical/major alarms raised during the past 48 hours. The table displays the
following details:
Displays the severity of the alarm. It can be either Critical or Major.
Displays the time when the alarm was reported.
Displays the message associated with the alarm.
Displays the number of times during the past 48 hours such an alarm was generated.
front panel. It displays the following details in a tabular format:
Displays the name of the port (ge1-8, me1 or up1)
Displays the status of the port, either— Up or Down
Displays the speed at which the port transmits or receives data.
Displays the status of the port, either— Full Duplex or Unknown.
set by the user.
Uptime
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
is the current operational time of the device
53-1002515-01
Advertisement
Table of Contents
Troubleshooting
