Configuring Redundancy Settings - Brocade Communications Systems RFS6000 System Reference Manual

•
•
•
•
•

Configuring Redundancy Settings

To configure switch redundancy:
1. Select Services > Redundancy from the main menu tree.
NOTE
Clients on an independent WLAN will not see any disruptions on a switch fail-over.
2. Refer to the Configuration field to define the following:
Enable Redundancy
Redundancy Switch IP Define the destination IP address used to send heartbeats and update messages.
Mode
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01
Configuring Redundancy Settings
Reviewing Redundancy Status
Configuring Redundancy Group Membership
Redundancy Group License Aggregation Rules
Managing Clustering Using the Web UI
The Redundancy screen displays with the Configuration tab selected.
Select this checkbox to enable/disable clustering. Clustering must be disabled to
set a redundancy related parameter. All the modifiable values are grayed out if
enabled
A member can be in either in
all 'Active' members adopt Access Ports except the 'Standby' members who adopt
Access Ports only when an 'Active' member has failed or sees an access-port not
adopted by a switch.
Primary Standby
or mode. In the redundancy group,
5
295