Brocade Communications Systems RFS6000 System Reference Manual page 378

6
1. Select Security > Wireless Firewall from the main tree menu.
2. Click the Configuration tab.
3. Click the ACL tab.
4. Select an ACL from the ACLs field.
5. Click the Edit button within the Associated Rules field.
6. Use the Precedence field to modify the precedence (priority) between 1 and 5000.
NOTE
If adding an access control entry to an ACL using the switch SNMP interface, Precedence is a
required parameter.
7.
8. Select the Logging checkbox to generate log messages when a packet has been forwarded,
9. If mark is selected from within the Operations drop-down menu, the Attribute to mark field
10. From within the Filters field, modify (if necessary) the Source Mask Length from the drop-down
11. Use the Source Address field to revise (if necessary) the IP address where the packets are
NOTE
If an Extended IP ACL is used, a Destination Wildcard/Mask and Destination Address are required.
366
The rules associated with the selected ACL display in the Associated Rules section.
The rules within an ACL are applied to packets based on their precedence value. Rules with
lower precedence are always applied first.
Use the Operation drop-down menu (if necessary) to modify the permit, deny or mark
designation for the ACL. If the action is to mark, the packet is tagged for priority.
denied or marked based on the criteria specified in the access lists.
becomes enabled. If necessary, select the 802.1p (0 - 7) or TOS(0 - 255) checkbox and define
the attribute receiving priority with this ACL mark designation.
menu.
The source is the source address of the network or host in dotted decimal format. The
Source-mask is the network mask.
sourced.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01