Brocade Communications Systems RFS6000 System Reference Manual page 475

Configuring E-mail Notifications
To enable e-mail notification:
1. Select Management Access > SNMP Trap Configuration from the main menu tree.
2. Click the Email Configuration button to launch a dialogue where you can configure outgoing
3. Check the Enable SMTP box to enable the outgoing mail server on the switch. In order to use
Name Enter the hostname of your outgoing SMTP mail server. This is the server that is used to deliver outgoing mail.
Port Specify the port number used by your outgoing SMTP server. In many cases this is port 25.
User Name Enter the username for the user which will be sending outgoing mail through the SMTP server.
Password Enter the password associated with the above username.
Enable Authentication Check the Enable Authentication box to enable support for SMTP Authentication which is required for certain
outgoing SMTP servers.
4. Configure the mail-to section of the page as follows:
To Address(es) Specify an e-mail address or addresses that notifications will be sent to. To add an e-mail address to the list, enter
the email address in the To Address(es) field and click the Add button. There is a maximum of 4 e-mail addresses
allowed on the list.
Add Click the Add button to add an e-mail address that is in the To Address(es) field to the list below.
Remove Select an e-mail address from the list and click the Remove button to delete that address from the list.
From Address Enter an e-mail address that will serve as the From address for the notifications sent by the switch.
Subject Prefix Enter a short subject line that will prepend the subject line in each outgoing notification e-mail.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01
E-mail servers and addresses for alerts.
E-mail notification on the switch, this box must be checked.
Configure the SMTP mail server properties as follows:
7
463