Brocade Communications Systems RFS6000 System Reference Manual page 341

11. If the onboard SOLE engine is enabled to locate Ekahau tags, enter a Locate Interval in
12. Click the Apply button to save the Locate Interval value.
13. Click the Revert button to cancel any changes made within Locate Interval value and revert
If the onboard SOLE engine is enabled to locate Ekahau tags the following information will be
displayed for each located client:
MAC Lists the MAC Addresses of all Clients which have been located by the switch.
Location: Displays the value of the X Coordinate for each located client. The X coordinate is relative to the origin point of
X Coordinate 0,0 in the upper left corner of the site map.
Location: Displays the value of the Y Coordinate for each located client. The X coordinate is relative to the origin point of
Y Coordinate 0,0 in the upper left corner of the site map.
Timestamp Displays the last time for each client that its location was computed by the switch.
Zone Lists the last known zone for each located client. Zone configuration can be defined using the CLI interface
only. When no zones are configured, the switch defaults the entire site to Zone 0.
NOTE
Zone configuration can be defined using the CLI interface only. For information on Zone
Configuration please see the Brocade RF Switch CLI Reference.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01
seconds to specify how often the known tags are located by the SOLE engine.
back to the last saved configuration.
5
329