Brocade Communications Systems RFS6000 System Reference Manual page 218

4
Retry Threshold (avg Specify the retry threshold, which is the average number of retries per packet to cause a radio to re-run channel
attempts/pkt) selection. The valid range is between 0.0 and 15.0. The default threshold is 14.0.
Hold Time (seconds) Specify the global hold time in seconds. The valid range is between 30 and 65535 seconds. Default hold time is
3600 seconds.
Assignable Power Specify a valid range for the power in dBm. The valid minimum is 4 and maximum is 20. Default range is 4 to 16
Range (dBm) dBm.
Scan Dwell Time Specify the RF Scan Dwell Time in seconds. The valid range is between 1 and 10 seconds. Default dwell time is 1
(seconds) second.
7.
Interference Recovery Check this box to enable monitoring for interference and self-healing it by rescuer.
Faulty Radio Recovery Check this box to enable monitoring for defective radio and self-healing by its rescuer.
Coverage Hole
Recovery
8. The Diagnostic Configuration section contains the following two configuration items:
Verbose Mode
Extensive Scan Mode
9. The Calibration Schedule contains the following calibration settings:
Schedule Calibration
Start Date
Start Time
Interval
10. Once the settings have been configured, click the Run Calibration button to start a Smart RF
206
The Monitoring/Recovery Configuration section contains the following configuration items:
Check this box to enable monitoring and recovering for coverage holes.
Check this box to enable verbose diagnostic information for Smart RF.
Check this box to enable extensive scan mode when using Smart RF.
Check this box to enable scheduled RF Calibration.
If scheduled RF Calibration is enabled, enter a start date in MM/DD/YY format for the start
date of scheduled calibration.
If scheduled RF Calibration is enabled, enter a start time in HH:MM:SS format for the start
time of scheduled calibration.
If scheduled RF Calibration is enabled, enter an interval in days for how long the
scheduled calibration should continue after its start date.
calibration.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01