Brocade Communications Systems RFS6000 System Reference Manual page 146

4
8. Refer to the Accounting field and define the following credentials for a primary and secondary
Accounting Server Enter the IP address of the primary and secondary server acting as the NAC accounting server.
Address
Accounting Port Enter the TCP/IP port number for the primary and secondary server acting as the NAC accounting data source. The
default port is 1813.
Accounting Shared Provide a shared secret (password) for user credential authentication with the primary or secondary NAC accounting
Secret server.
Accounting Timeout Enter a value (between 1 and 300 seconds) to indicate the number of elapsed seconds causing the switch to time
out a request to the primary or secondary accounting server.
Accounting Retries Enter a value between 1 and 100 to indicate the number of times the switch attempts to reach the primary or
secondary NAC accounting server before giving up.
Accounting Mode Use the
Start-Interim-Stop
9. Select the Re-authentication checkbox to force a periodic re-authentication with the NAC
10. Refer to the Advanced field to define the authentication protocol used with the NAC Server.
PAP PAP - Password Authentication Protocol sends a username and password over a network to a server that compares
the username and password to a table of authorized users. If the username and password are matched in the table,
server access is authorized.
CHAP CHAP is an encrypted authentication method based on Microsoft's challenge/response authentication protocol.
DSCP/TOS Optionally mark packets with a DiffServ CodePoint (DSCP) in its header. The DSCP value is stored in the first 6 bits
of the Type of Service (ToS) field that is part of the standard IP header. The DCSP values are associated with a
forwarding treatment called Per Hop Behaviors (PHB). Service can be provisioned (if necessary) by assigning a
DCSP point code from 1 - 6.
11. Refer to the Status field for the current state of the requests made from applet. This field
12. Click OK to use the changes to the running configuration and close the dialog.
13. Click Cancel to close the dialog without committing updates to the running configuration.
Configuring Different Encryption Types
To configure the WLAN data encryption options available on the switch, refer to the following:
•
•
•
134
NAC Server.
Accounting Mode
drop-down menu to define the accounting mode as either
. Define the interval (in seconds) used with the selected accounting mode.
server.
Periodic repetition of the authentication process provides ongoing security for currently
authorized connections. Define an interval between 30 and 65535 seconds.
displays error messages if something goes wrong in the transaction between the applet and
the switch.
Configuring WEP 64
Configuring WEP 128 / KeyGuard
Configuring WPA/WPA2 using TKIP and CCMP
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
Start-Stop Stop Only,
, or
53-1002515-01