Brocade Communications Systems RFS6000 System Reference Manual page 138

4
Once the properties of the advanced hotspot have been defined, the file can be installed on the
switch and used to support the hotspot. The following parameters are required to upload the file:
126
Ensure Advanced is selected from within the This WLAN's Web Pages are of the drop-down
menu.
a. Specify a source hotspot configuration file. The file used at startup automatically displays
within the File parameter.
b. Refer to the Using drop-down menu to configure whether the hotspot file transfer is
conducted using FTP or TFTP.
c. Enter the IP Address of the server or system receiving the source hotspot configuration.
Ensure that the IP address is valid or risk jeopardizing the success of the file transfer.
d. If using FTP, enter the User ID credentials required to transfer the configuration file from
an FTP server.
e. If using FTP, enter the Password required to send the configuration file from an FTP server.
f. Specify the appropriate Path name to the hotspot configuration on the local system disk or
server.
g. Once the location and settings for the advanced hotspot configuration have been defined,
click the Install button to use the hotspot configuration with the switch.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01