Brocade Communications Systems RFS6000 System Reference Manual page 523

1. Go to Network> Access Port Radios and click on the Global Settings button.
2. Uncheck the Adopt Unconfigured Radios Automatically option to prevent the switch from
3. Configure the client bridge back haul WLAN, base bridge and client bridge radios on the switch
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01
automatically adopting new APs when they are connected to the switch.
using the Command Line Interface (CLI) commands listed below.
Client Bridge Back Haul WLAN Configuration:
Brocade Mobility RFS7000(config-wireless)#wlan 1 enable
Brocade Mobility RFS7000(config-wireless)#wlan 1 ssid meshWlan
Brocade Mobility RFS7000(config-wireless)#wlan 1 independent
Brocade Mobility RFS7000(config-wireless)#wlan 1 client-bridge-backhaul
enable
Base Bridge Radio Configuration: (Brocade Mobility 5181 Access Point that is wired to the
switch)
Brocade Mobility RFS7000(config-wireless)#radio add 1 "base bridge radio
mac" 11bg aap51x1
Brocade Mobility RFS7000(config-wireless)#radio add 2 "base bridge radio
mac" 11a aap51x1
Brocade Mobility RFS7000(config-wireless)#radio 1 base-bridge enable
Brocade Mobility RFS7000(config-wireless)#radio 1 bss 1 1
(map the mesh WLAN if manual mapping is enabled, not needed otherwise)
Client Bridge Radios Configuration: (AP51x1's that are wirelessly connected)
Brocade Mobility RFS7000(config-wireless)#radio add 3 "client bridge radio
mac" 11bg aap51x1
Brocade Mobility RFS7000(config-wireless)#radio add 4 "client bridge radio
mac" 11a aap51x1
Brocade Mobility RFS7000(config-wireless)#radio 3 client-bridge enable
A
511