Brocade Communications Systems RFS6000 System Reference Manual page 334

5
To configure your site parameters:
1. .Select Services > RTLS from the main menu tree.
2. Select the Site tab.
3. Enter a Name and optionally a Description for the site:.
Name
Description Provide a description of the site where locationing is deployed. This is an optional field.
4. When mapping out a site for locationing an origin point must be selected in one of the corners
Length Enter the length of the site. This is the X axis of your site map based on the origin point of 0,0. The size is either in
feet or meters depending on which unit of measure is selected below. The valid range for length is 1-1000m or
1-3000ft.
Width Enter the width of the site. This is the Y axis of your site map based on the origin point of 0,0. The size is either in feet
or meters depending on which unit of measure is selected below. The valid range for width is 1-1000m or 1-3000ft.
Height Enter the height of the site. The size is either in feet or meters depending on which unit of measure is selected below.
The acceptable range for height is 0-20m or 0-60ft. Height is an optional parameter and is not taken into account by
the locationing algorithm.
Unit Use the pull-down menu to select the unit of measure used for dimensions. The options are feet or meters.
322
Enter a name for the site where locationing is deployed. This is for identification purposes only.
of the site. That origin will become the upper left corner of the site map with coordinates of 0,0.
The length and width of the site is then mapped out on the X and Y axes. Those length and
width along with the height are entered into the field below.
Define the Dimensions and Unit of measure used to define the site size:
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01