Debugging The Applet - Brocade Communications Systems RFS6000 System Reference Manual

8
5. Use the To drop-down menu (within the Target field) to define whether the target panic file is to
6. Provide the name of the file to be transferred to the location specified within the File field.
7.
8. If Server has been selected as the source, enter the IP Address of the destination server or
9. If Server has been selected as the source, enter the User ID credentials required to send the
10. If Server has been selected as the source, enter the Password required (for FTP transfers) to
11. Specify the appropriate path name to the target directory on the local system disk or server as
12. Refer to the Status field for the current state of the requests made from applet. This field
13. Click the Transfer button when ready to move the target file to the specified location. Repeat
14. If a problem condition is discovered during the file transfer, click the Abort button to terminate
15. Click the Close button to exit the dialogue and abandon the transfer.

Debugging the Applet

Refer to the Applet Debugging screen to debug the applet. This screen allows you to view and
debug system events by a criticality level you define.
498
be sent to the system's local disk (Local Disk) or to an external server (Server).
If Server has been selected as the source, use the Using drop down-menu to configure whether
the panic file transfer will be sent using FTP or TFTP.
system receiving the target panic file.
file to the target location. The User ID is required for FTP transfers only.
send the file to the target location.
configured using the "To" parameter. If local server is selected, use the Browse button to
specify a location on your local machine.
displays error messages if something goes wrong in the transaction between the applet and
the switch.
the process as necessary to move each desired log file to the specified location.
the transfer.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01