Brocade Communications Systems RFS6000 System Reference Manual page 465
Provides centralized wireless lan (wlan)
Hide thumbs
Also See for RFS6000:
- Cli reference manual (839 pages) ,
- System reference manual (574 pages)
Table of Contents
Advertisement
1. Select Management Access > Access Control from the main menu tree.
2. Refer to the Management Settings field to enable or disable the following switch interfaces:
Secure Management
Select this checkbox to allow management VLAN access to switch resources. The management VLAN is used to
(on Management VLAN
establish an IP connection to the switch from a workstation connected to a port in the VLAN. By default, the active
only)
management VLAN is VLAN 1, but you can designate any VLAN as the management VLAN. Only one management
VLAN can be active at a time. This option is disabled (not selected) by default.
Enable Telnet
Select this checkbox to allow the switch to use a Telnet session for communicating over the network. This setting is
enabled by default.
Port
Define the port number used for the Telnet session with the switch. This field is enabled as long as the Enable Telnet
option remains enabled. The default port is port 23.
Enable SNMP v2
Select this checkbox to enable SNMPv2 access to the switch over the SNMPv2 interface. This setting is enabled by
default.
Enable SNMP v3
Select this checkbox to enable SNMPv3 access to the switch over the SNMPv3 interface. This setting is enabled by
default.
Retries
Define the number of retries the switch uses to connect to the SNMP interface if the first attempt fails. The default
value is 3 retry attempts.
Timeout
When the provided interval is exceeded, the user is logged out of the SNMP session and forced re-initiate their
connection. The default value is 10 minutes.
Enable HTTP
Select this checkbox to enable HTTP access to the switch. The Hypertext Transfer Protocol (HTTP) is an
application-level protocol for distributed, collaborative, hypermedia information systems. This setting is enabled by
default.
Enable HTTPS
Select this checkbox to enable HTTPS access to the switch. This setting is enabled by default.
HTTPS Trustpoint
Use the Trustpoint drop-down menu to select the local or default trustpoint used with a HTTPS session with the
switch. For information on creating a new certificate, see
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01
Creating Server Certificates on page
7
6-433.
453
Advertisement
Table of Contents
Troubleshooting
