Brocade Communications Systems RFS6000 System Reference Manual page 513

1. Select Diagnostics > Ping from the main menu.
2. Refer to the following information displayed within the Configuration tab:
Description
Destination IP
Timeout (sec)
No. of Probes
Frequency
3. To edit the properties of an existing ping test, select a ping based on the description listed and
4. Select an existing ping test from those displayed within the Configure tab and click the Delete
5. Click the Add button to display a screen used to define the attributes of a new ping test. For
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01
Displays the user assigned description of the ping test. The name is read-only. Use
this title to determine whether this test can be used as is or if a new ping test is
required.
Displays the IP address of the target device. This is the numeric destination for the
device sent the ping packets. If this address does not accurately reflect the ping
destination target, the ping test will not be successful.
Displays the timeout value (in seconds) used to timeout the ping test if a round trip
packet is not received from the target device.
Displays the number of packets transmitted to the target IP address to discern the
round trip time between the switch and its connected device.
Define the interval (in seconds) between ping packet transmissions. Define a longer
interval if high levels of network congestion are anticipated between the switch and
its target device. Use a value of 0 to execute a single ping test or stop a currently
executing ping test.
click the Edit button. For more information, see
Modifying the Configuration of an Existing Ping Test on page
button to remove the ping test from those displayed.
more information, see Adding a New Ping Test on page
8-502.
8-502.
8
501