Brocade Communications Systems RFS6000 System Reference Manual page 313

3. Refer to the following information within the Member tab:
IP Address
Status
Last Seen
AP Adoption Count
AAP Adoption Count
AP License Count
AAP License Count
Mode
4. Select a row, and click the Details button to display additional details for this member. For
5. Select a row and click the Delete button to remove a member from the redundancy group. The
6. Click the Add button to add a member to the redundancy group. The redundancy group should
Displaying Redundancy Member Details
Use the Details screen (in conjunction with its parent Member screen) to display additional (more
detailed) information on the group member selected within the Member screen.
To review the details
1. Select Services > Redundancy from the main menu tree.
2. Select the Member tab.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01
Displays the IP addresses of the redundancy group member.
Displays the current status of this group member. This status could have the
following values:
•
Configured - The member is configured on the current wireless service module.
•
Seen - Heartbeats can be exchanged between the current switch and this
member.
•
Invalid - Critical redundancy configuration parameter(s) of the peer (heartbeat
time, discovery time, hold time, Redundancy ID, Redundancy Protocol version
of this member) do not match this switch's parameters.
•
Not Seen - The member is no more seen by this switch.
•
Established - The member is fully established with this current module and
licensing information already been exchanged between this switch and the
member.
•
Unknown - No status information could be obtained.
Displays the time when this member was last seen by the switch.
Displays the number of Access Ports adopted by this member.
Displays the number of Adaptive APs adopted by this member.
Displays the number of Access Port licenses installed on this member.
Displays the number of Adaptive AP licenses installed on this member.
The Redundancy Mode could be Active or Standby depending on the mode
configuration on the member. Refer to the Configuration screen to change the
mode.
more information, see Displaying Redundancy Member Details on page
redundancy group should be disabled to conduct an Add or Delete operation.
be disabled to conduct an Add or Delete operation. For more information, see
Redundancy Group Member on page
The Redundancy screen displays with the Configuration tab selected.
5-303.
5
5-301.
Adding a
301