Brocade Communications Systems RFS6000 System Reference Manual page 227

17. In the Max Airtime for Reserved for Roaming field, specify a maximum percentage out of the
18. Refer to the Status field for the current state of the requests made from applet. This field
19. Click OK to use the changes to the running configuration and close the dialog.
20. Click Cancel to close the dialog without committing updates to the running configuration.
Configuring Rate Settings
Use the Rate Settings screen to define a set of basic and supported rates for the target radio. This
allows the radio to sync with networks using varying data rates and allows the radio to default to a
predefined set of data rates when higher data rates cannot be maintained.
To configure a radio's rate settings:
1. Click the Rate Settings button in the radio edit screen to launch a screen wherein rate settings
2. Check the boxes next to all Basic Rates you want supported by this radio.
3. Check the boxes next to all Supported Rates you want supported by this radio.
4. Click the Clear all rates button to uncheck all of the Basic and Supported rates.
5. Refer to the Status field for the current state of the requests made from applet. This field
6. Click OK to use the changes to the running configuration and close the dialog.
7.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01
radio's total airtime that may be used for voice Clients which roam from other APs.
displays error messages if something goes wrong in the transaction between the applet and
the switch.
can be defined for the radio.
Basic Rates are used for management frames, broadcast traffic, and multicast frames. If a
rate is selected as a basic rate, it is automatically selected as a supported rate.
Supported Rates allow an 802.11 network to specify the data rate it supports. When a station
attempts to join the network, it checks the data rate used on the network. If a rate is selected
as a basic rate, it is automatically selected as a supported rate.
displays error messages if something goes wrong in the transaction between the applet and
the switch.
Click Cancel to close the dialog without committing updates to the running configuration.
4
215