Brocade Communications Systems RFS6000 System Reference Manual page 548

B
•
Radius Server is rejecting the user
Ensure the following have been attempted:
•
•
Time of Restriction configured does not work
Ensure that date on the system matches your time
Authentication fails at exchange of certificates
Ensure the following have been attempted:
•
•
When using another Brocade Mobility RFS7000 (switch 2) as RADIUS server,
access is rejected
Ensure the following have been attempted:
•
•
•
Authentication using LDAP fails
Ensure the following have been attempted:
•
•
•
•
VPN Authentication using onboard RADIUS server fails
Ensure the following have been attempted:
•
•
•
536
Ensure that the WLAN settings haves been set to use the on-board/local Radius server by
entering the local IP address or the switch management VLAN IP address
Verify a SAVE was done after adding this user.
Is the user present in a group?
•
If yes, check if the WLAN being accessed is allowed on the group
•
Check if time of access restrictions permit the user.
Verify that valid certificates were imported.
If the Supplicant has "Validate Server Certificate" option set, then make sure that the right
certificates are installed on the client.
Make sure that the user, group and access policies are properly defined on switch 2
Add a AAA client on switch 2 with a VLAN interface IP address which can communicate with
switch 1
Save the current configuration
Is LDAP server reachable?
Have all LDAP attributes been configured properly?
Dbtype must be set to LDAP in AAA configuration
Save the current configuration
Ensure that the VPN user is present in AAA users
This VPN user MUST NOT added to any group.
Save the current configuration
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01