Brocade Communications Systems RFS6000 System Reference Manual page 340

5
1. .Services > RTLS from the main menu tree.
2. Select the Ekahau tab.
3. Check the Enable checkbox to globally enable Ekahau support on the switch.
4. Enter the Multicast MAC Address used for all Ekahau tags to send updates via multicast to the
NOTE
To use the onboard SOLE engine to locate Ekahau tags, site parameters, AP location (Command Line
Interface only) and Zone configuration (optional, Command Line Interface only) must be configured.
5. Specify the IP Address of the Ekahau RTLS engine server.
6. Enter the Port number used to communicate with the Ekahau RTLS engine. The port range
7.
8. Click the Revert button to cancel any changes made within Multicast MAC Address, IP Address
9. If the Multicast MAC Address, IP Address and Port values are configured and Ekahau RTLS
No. of RX Msgs Displays the number of messages received by the switch from the external Ekahau RTLS engine.
Last Msg RX Time Displays the Date and Time that the last message was received from the external Ekahau RTLS engine.
No. of TX Msgs Displays the number of messages transmitted by the switch to the external Ekahau RTLS engine.
Last Msg TX Time Displays the Date and Time that the last message was sent to the external Ekahau RTLS engine.
No. of Tag Reports Displays the number of Tag Reports received from the external Ekahau RTLS engine.
10. To use the onboard SOLE engine to locate Ekahau tags check the Enable checkbox. This is
328
This takes effect immediately when the box is checked.
MAC address specified. Typically the MAC address will start with 01-0C-CC-XX-XX-XX.
must be between 1000 and 9000.
Click the Apply button to save the Multicast MAC Address, IP Address and Port information
and Port settings and revert back to the last saved configuration.
support is enabled the following information will be displayed:
enabled immediately after checking the box.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01