ST STM32F413 Reference Manual page 170

Reset and clock control (RCC) for STM32F413/423
Bit 28 SFTRSTF: Software reset flag
Bit 27 PORRSTF: POR/PDR reset flag
Bit 26 PINRSTF: PIN reset flag
Bit 25 BORRSTF: BOR reset flag
Bit 24 RMVF: Remove reset flag
Bits 23:2 Reserved, must be kept at reset value.
Bit 1 LSIRDY: Internal low-speed oscillator ready
Bit 0 LSION: Internal low-speed oscillator enable
170/1284
Set by hardware when a software reset occurs.
Cleared by writing to the RMVF bit.
0: No software reset occurred
1: Software reset occurred
Set by hardware when a POR/PDR reset occurs.
Cleared by writing to the RMVF bit.
0: No POR/PDR reset occurred
1: POR/PDR reset occurred
Set by hardware when a reset from the NRST pin occurs.
Cleared by writing to the RMVF bit.
0: No reset from NRST pin occurred
1: Reset from NRST pin occurred
Cleared by software by writing the RMVF bit.
Set by hardware when a POR/PDR or BOR reset occurs.
0: No POR/PDR or BOR reset occurred
1: POR/PDR or BOR reset occurred
Set by software to clear the reset flags.
0: No effect
1: Clear the reset flags
Set and cleared by hardware to indicate when the internal RC 40 kHz oscillator is stable.
After the LSION bit is cleared, LSIRDY goes low after 3 LSI clock cycles.
0: LSI RC oscillator not ready
1: LSI RC oscillator ready
Set and cleared by software.
0: LSI RC oscillator OFF
1: LSI RC oscillator ON
DocID029473 Rev 3
RM0430