Setting The Timing Analyzer Trigger - HP 1652B Getting Started Manual

Setting the
Timing
Analyzer
Trigger
Your timing measurement requires the timing analyzer to display the
timing waveforms present on the enable lines when the routine is
running. Since the state analyzer will trigger on address 0550, you will
want to arm the timing analyzer with the state analyzer, so the timing
waveforms will be captured at the same time.
Configure the Timing Trace Specification menu as shown below.
U
Armed by field
HP 16528/1653B
Timing/State/Scope Measurement Example
Front-Panel Reference
2741
I]-
Timing Trace Specification
Trace modes]
t
firmed tty 1-1
Rcqulsltion moee~Transltfo~~1 ]
Label > 1~llLOUTPfljLDISPI~llLKEYBDj
Base >
IHexjlHexI[]
Find
Pat tern
pF-TT--'XliX]
present f or l>i [ 30 ns 1
Then I lna
Eege =.I'.=
Figure 27-8. Set Armed By Field to INIT
1. Display the Timing Trace Specification menu.
2. Select the Armed by field.
3. Select the INIT (state analyzer) option in the pop-up.