Self Test - HP 1652B Getting Started Manual

If for some reason both of the internal analyzers are off, selecting the
External BNC Configuration
option gives you the message "BNC
output armed by : Off (note: both machines are off)."
Self Test
I
Note '@
The
Self Test
option in the I/O menu allows you to run a self test on the
logic analyzer. The self test is on the PV disk. Selecting this option
gives you a pop-up telling you what effect the self test has on
the analyzer. The pop-up also contains two fields:
Cancel
and Start
Self Test. Cancel
lets you change your mind about running the self test.
Selecting this field returns you to the I/O menu. Selecting the Start
Self
Test
field causes your logic analyzer to load the self test from the disk
and run through it. Before selecting this field you must insert the
master disk with the self test on it.
Running the self test destroys all current configurations and data.
Make sure that you save any important configurations on a disk before
running any of the self tests.
For a description of the individual self tests, refer to appendix E, in
volume 2 of this manual.
I/O Menu
S-18
HP
16528/1653B -
Front-Panel Reference