How Do I Re-Configure The Logic Analyzer; Connecting The Timing Analyzer Probes - HP 1652B Getting Started Manual

Logic
Hide thumbs Also See for 1652B:
Table of Contents

Advertisement

How Do I
Re-Configure
the Logic
In order to make this measurement, you must reconfigure the logic
analyzer so Analyzer 2 is a timing analyzer. You leave Analyzer
1
as a
state analyzer since you will use the state analyzer to trigger on address
8930.
-
Analyzer?
Configure the logic analyzer so Analyzer 2 is a timing analyzer as
shown:
Systiwi
Conflgurstlon
Ilnalyzer
2
'
Figure
21-5.
System Configuration Menu
Connecting
the
At this point you would connect the probes of pods 4 and 5 as follows:
Timing Analyzer
Probes
l
Pod 4 bit 0 to address strobe (AS).
l
Pod 4 bit
1
to the system clock.
I
l
Pod 4 bit 2 to low data strobe (LDS).
l
Pod 4 bit 3 to upper data strobe (UDS).
l
Pod 4 bit 4 to the read/write (R/W).
l
Pod 4 bit 5 to data transfer acknowledge (DTACK).
l
Pod 5 bits 0 through 7 to address lines A0 through A7.
l
Pod 5 bits 8 through 15 to data lines DO through D7.
Timing/State Measurement Example
HP 16528/16538
21-8
Front-Panel Reference

Advertisement

Table of Contents
loading

This manual is also suitable for:

1653b

Table of Contents