Table of Contents
Advertisement
Installation
Introduction
This section of the manual contains information
and instructions necessary for
setting up the HP 1652B/l653B
Logic Analyzer.
This includes inspection
procedures, power requirements, hardware connections and configurations,
and
packaging information.
Safety
The safety symbols used with Hewlett-Packard
instruments are illustrated in the
Considerations
front of this manual. WARNING
and CAUTION
symbols and instructions should
be reviewed before operating the instrument.
These warnings and cautions must
be followed for your own protection and to avoid damaging the instrument.
Initial
Inspection
Inspect the shipping container for damage. If the shipping container or cushioning
material is damaged, keep it until the contents of the shipment have been checked
for completeness and the instrument has been checked mechanically and
electrically.
The contents of the shipment are listed under "Accessories Supplied"
inSection 1. If the contents are incomplete,
if there is mechanical damage or
defect, or if the instrument does not operate properly, notify the nearest
Hewlett-Packard
office. If the shipping container is damaged, or the cushioning
materials show signs of stress, notify the carrier as well as the Hewlett-Packard
office. Keep the shipping materials for the carrier's inspection.
The
Hewlett-Packard
office will arrange for repair or replacement at HP option
without waiting for claim settlement.
Operating
Disk
The instrument is shipped with a yellow protective disk in the disk drive. Before
Installation
applying power to the instrument, remove the protective disk from the disk drive
and install the operating system disk. Reinstall the protective disk whenever the
instrument is to be transported.
Power
The HP 1652B/1653B Logic Analyzer requires a power source of either 115 Vat or
Requirements
230 Vat, -22% to + lo%, single phase, 48 to 66 Hz, 200 Watts maximum power.
ub
BEFORE
CONNECTING
POWER
TO THIS INSTRUMENT,
be sure the Line
Caution
Voltage Select switch on the rear panel of the instrument is set properly and the
correct fuse is installed.
HP 1652B/1653B
Service
Manual
Installation
2-1
Advertisement
Chapters
Table of Contents
