Setting The Timing Analyzer Trigger - HP 1652B Getting Started Manual

Setting the
Timing
Analyzer
Trigger
Your timing measurement requires the timing analyzer to display the
timing waveforms present on the buses when the routine is running.
Since you triggered the state analyzer on address 8930, you want to
trigger the timing analyzer so the timing waveforms can be time
correlated with the state listing.
To set up the logic analyzer so that the state analyzer triggers the
timing analyzer, perform these steps:
1. Display the Timing Trace Specification menu.
2. Place the cursor on the Armed by
field and press SELECT.
3. Place the cursor on the 68000STATE option in the pop-up and
press SELECT.
Your timing trace specification should match the menu shown:
State Analyzer
Arms Timing
Analyzer
piiZEK+
Tlmlng Trace Speclflcatlon
Trace mode[~[
*firmed by 1-1
flcquisition mode[ Transitional 1
Label > lCLoCKllFlSI[LDSllUDSmIJR/HmjlDFITCI]
Base ) pzlIjHexI[HexIIHerII]
Find
Pat tern
[77llixIImmKjll
present for 1,1 1
30 ns ]
Thin I lncl
Edge D.DI[.li.aD
Figure 21-8. Armed by
68000
STATE
Timing/State Measurement Example
21-10
HP 16528/16538
Front-Panel Reference