Timing/State Measurement Example; Introduction - HP 1652B Getting Started Manual

21
-
Timing/State Measurement Example
Introduction
In this chapter you will learn how to use the timing and state analyzers
interactively by setting up the logic analyzer to simulate a simple
timing/state measurement. Since you may not have the same test
circuit available, we will give you the measurement results as actually
measured by the logic analyzer.
The exercise in this chapter is organized differently than the exercises
in the previous chapters. Since you have already set up both the timing
and state analyzers, you should be ready to set them up for this
simulated measurement by just looking at the menu pictures.
Any new set-ups in this exercise will be explained in task format steps
like the previous chapters.
To gain confidence using your logic analyzer, we recommend that you
configure the menus as you follow the simulated measurement example
up to section "Acquiring the Data." From that section unto the end,
you will see the measurement results on the display screens as if you
had the real test circuit connected, and as if you had selected RUN.
-
HP 16528/1653B
Timing/State Measurement Example
Front-Panel Reference
21-l