Armingthescope - HP 1652B Getting Started Manual

Arming 'the
Scope
Before the scope signals can be time-correlated and combined with the
Timing Waveforms display, the scope must be armed by the timing
analyzer and set to trigger immediately.
--
Set the Armed by field and Mode field in the Trigger menu as shown
below.
'Scope]- Trigger
tlode 1 Immediate ]
Run mode []
s/Dlv pzGq Delay 1-j firmed by IPoRTs-1
Figure 27-12. Set Armed by Field to PORTS
1. From the System Configuration menu, press the TRIG key. If you
don't go to the scope Trigger menu, just select the upper left-most
field and from there you can select the Scope field.
2. From the scope Trigger menu select the Armed by field.
3. From the pop-up select the PORTS field.
4. Select the Mode field and toggle to Immediate.
Timing/State/Scope Measurement Example
HP 16528/1653B
27-16
Front-Panel Reference