Trigger; Waveform Display - HP 1652B Getting Started Manual

Delay Post-trigger Range:
Time/Division Setting
Available Delav
25 ms - 5 s/div
100,~s - 25 msjdiv
5 ns - lOO&div
Trigger
Triggering on either input channel, rising
or
falling edge.
40 X (sldiv)
1s
10,000 X (s/div)
Trigger Level Range: dc Offset -~5 divisions.
Trigger Level Resolution (1:l Probe):
Trieeer Level Resolution
550 mV/div
100 mV/ div - 200 mV/div
500 mV/div - 1 Vldiv
~2 Vldiv
400 pv
2mV
10 mV
50 mV
Arming: Armed by the Run key, external BNC low input, or by Analyzer 1 or 2.
Trigger Modes
Immediate:
Triggers immediately after the condition is met.
Edge: Triggers on the rising or falling edge from channel 1
or 2.
Auto-Trigger: Self-triggers if no trigger condition is found within approximately 1
second after arming.
Trigger Out: Arms Analyzer 1 or 2, or triggers the rear panel BNC.
Waveform
Display Formats: 1 to 8 oscilloscope waveforms can be displayed.
Display
Display Resolution: 500 points horizontally, 240 points vertically.
Display Modes
Normal: New acquisitions replace old acquisitions on screen.
Accumulate: New acquisitions are added to the screen and displayed with the
previous acquisitions until a parameter is changed and a new acquisition is made.
Average: New acquisitions are averaged with older acquisitions and displayed.
The maximum number of averages is 256.
HP 1652B/1653B
Service Manual
General Information
1-17