HP 1652B Getting Started Manual page 499

-
Installation, Maintenance and Calibration
Introduction
This appendix contains information and instructions necessary for
preparing the HP 1652B/1653B Logic Analyzers for use. Included in
this section are inspection procedures, power requirements packaging
information, and operating environment. It also tells you how to load
the operating system and turn the logic analyzer on. Also included in
this appendix is information on calibration and maintenance that you
can do as an operator.
Initial
Inspection
Inspect the shipping container for damage. If the shipping container or
cushioning material is damaged, it should be kept until the contents of
the shipment have been checked for completeness and the instrument
has been checked mechanically and electrically. Accessories supplied
with the instrument are listed under "Accessories Supplied" in chapter
1 of this manual. An overview of the self-test procedure is in Appendix
E of this manual. The complete details of the procedure are in Chapter
6 of the Service manual. Electrical performance verification functions
are also in Chapter 3 of the Service Manual.
HP 16528/1653B
installation, Maintenance and Calibration
Front-Panel Reference
Dl m
If the contents are incomplete, if there is mechanical damage or defect,
or if the instrument does not pass the Self Test Performance
Verification, notify the nearest Hewlett-Packard Office. If the shipping
container is damaged, or the cushioning materials show signs of stress,
notify the carrier as well as the Hewlett-Packard Office. Keep all
shipping materials for the carrier's inspection. The Hewlett-Packard
office will arrange for repair or replacement at HP option without
waiting for claim settlement.