Table of Contents
Advertisement
,--
To change the base, place the cursor on the Base field and press
SELECT. You will see the following pop-up menu.
Figure
17-9.
Base Pop-Up Menu
If more than 20 channels are assigned to a label, the Binary option is
not offered in the pop-up. The reason for this is that when a symbol is
specified as a range, there is only enough room for 20 bits to be
displayed on the screen.
Decide which base you want to work in and choose that option from
the numeric Base pop-up menu.
If you choose the ASCII option, you can see what ASCII characters the
patterns and ranges defined by your symbols represent. ASCII
characters represented by the decimal numbers 0 to 127 (hex 00 to 7F)
are offered on your logic analyzer. Specifying patterns and ranges for
symbols is discussed in the next section.
llE'
Note
r(r;l
You cannot specify a pattern or range when the base is ASCII. First
define the pattern or range in one of the other bases, then switch to
ASCII to see the ASCII characters.
HP 1652806538
Timing Format Specification Menu
Front-Panel Reference
17-9
Advertisement
Chapters
Table of Contents
