HP 1652B Getting Started Manual page 249

-
Repetitive
Comparisons
with a
Stop
When you do a comparison in the repetitive trace mode, a stop
condition may be specified. The stop condition is either Stop
Measurement when Compare is Equal or Not Equal. In the case of
Equal, bits in the compare image must match the corresponding bits in
Condition
the acquired data image for the stop condition to be a true. In the case
of Not Equal, a mismatch on a single bit will cause the stop condition
to be true. When stop conditions are specified in two analyzers, both
analyzers stop when the stop condition of either analyzer is satisfied. It
is an OR function.
You access the stop measurement function by selecting the Specify
Stop Measurement field in either the Compare or Difference Listing
menus. When you select this field, the Stop Measurement Parameters
pop-up appears (see figure 12-4). The first field in this pop-up, just to
the right of Stop measurement contains either Off, X-O or Compare.
When this field is selected, a pop-up appears in which you select
Compare. When you select the Compare option, you can access and
select either the Equal or Not Equal option in the next field to the right.
[-7!ZiSl - [State Caqare 1
Speclf y Stop Heasurement
Show [Dlf foroncm Listlnq ] Find Dtfforanc
stop ner8urmnt Prrmtors
(Doncr
,op mosrurom~nt :
ore exception t
le descr lptlon
I
+0069 04m
+0070 0438
3
too7 1
04x c2 3
fizGq
043D 34
+0073 043F 09 i
wo74 0440
c2 3
+0075 044 1
34
+0076 0443
01 3
+0077 OBB6 47 2
+0078 Obl37 02 +0079 0444
Fl
5
+ooeo 0888
44 2
Figure
12-4.
Specify Stop Measurement Field
Also available is Store exception to disk which allows you to specify a
file on the disk that exceptions can be stored in. The default filename is
EXCEPTION.
HP
16528/16538
Front-Panel Reference
State Compare Menu
12-7