Hp-Ib Address Selection; Service Manual Contents-1 - HP 1652B Getting Started Manual

0101
0102
D103
D104
EOI
DAV
NRFD
NDAC
IFC (BCL)
SRQ
ATN (MRE >
SHIELD
01652~65
D105
0106
D107
D108
REN
P/O TWISTED PAIR WITH 6
P/O TWISTED PAIR WITH 7
P/O TWISTED PAIR WITH 8
SHOULD BE GROUNDED
P/O TWISTED PAIR WITH 9
NEAR TERMINATION OF
OTHER WIRE OF TWISTED PAIR
P/O TWISTED PAIR WITH 10
P/O TWISTED PAIR WITH
11
I
SIGNAL GROUND
a
TYPE 57 MICRORIBBON CONNECTOR
Figure
2-3.
HP-IB Interface Connector
HP=IB Address
Each instrument connected to the HP-IB interface bus requires a unique address.
Selection
Installation
HP
16528/1653B
2-6
Service Manual
The address provides a method for the system controller to select individual
instruments on the bus. The address of the HP 1652B/1653B defaults at power up
to decimal
"07."
'To change the address of the HP 1652B/1653B proceed as follows:
--
1.
Press the I/O key on the front-panel keypad and the I/O menu will appear on
screen.
2. Rotate the KNOB until "I/O Port Configuration" is highlighted.
3. Touch the SELECT key and the External I/O Port Configuration menu will
appear on screen.
External II0 Port Conliguration
(Done)
1 Printer
connected to [RS-232-C] Control I et- connected
to [HpIel
RS-232-C
Configuration
Protocol : [piEm6Fq
Stop Bits : I]
Parity ' jNone]
Baud
rate * 11
Data Bits : 8
HP16 Configuration
HP18 Address : rj
Psinter Information
Pr lnter :lLaserJet]
Paper ufdth : w]
Figure 2-4. External l/O Port Configuration Menu
4. Select the HP-IB Address field with the KNOB and press the SELECT key.
5. When the pop-up field appears on screen, rotate the KNOB to select the
desired HP-IB address.