HP 1652B Getting Started Manual page 195

State Format Specification Menu
Introduction
This chapter describes the State Format Specification menu and all
pop-up menus that you will use on your state analyzer. The purpose
and functions of each menu are explained in detail, and we have
included many illustrations and examples to make the explanations
clearer.
Accessing the
The State Format Specification menu can be accessed by pressing the
State Format
Specification
Menu
FORMAT key on the front panel. If the Timing Format Specification
Menu is displayed when you press the FORMAT key, you will have to
switch analyzers. This is not a problem, it merely indicates that the last
action you performed in the System Configuration Menu was on the
timing analyzer.
State Format
Specification
Menu
The State Format Specification menu lets you configure the logic
analyzer to group channels from your microprocessor into labels you
assign for your measurements. You can set the threshold levels of the
pods assigned to the state analyzer, assign labels and channels, specify
symbols, and set clocks for triggering.
At power up, the logic analyzer is configured with a default setting.
You can use this default setting to make a test measurement on the
system under test. It can give you an idea of where to start your
measurement. For an example of setting up configurations for the state
analyzer, refer to your Getting Sttied Guide or "State Analyzer
Measurement Example" in Chapter l5 of this manual.
HP 16528/1653B
State Format Specification Menu
Front-Panel Reference
0-l