HP 1652B Getting Started Manual page 309

17
Timing Format Specification Menu
Introduction
This chapter describes the Timing Format Specification menu and all
the pop-up menus that you will use on your timing analyzer. The
purpose and function of each pop-up menu is explained in detail, and
we have included many illustrations and examples to make the
explanations clearer.
Accessing the
The Timing Format Specification menu can be accessed by pressing
Timing Format
the FORMAT key on the front panel. If the State Format Specification
Specification
Menu
Menu is displayed when you press the FORMAT key, you will have to
switch analyzers. This is not a problem, it merely indicates that the last
action you performed in the System Configuration Menu was on the
state analyzer.
Timing Format
The Timing Format Specification menu lets you configure the timing
Specification
analyzer to group channels from your microprocessor into labels you
Menu
assign for your measurements. You can set the threshold levels of the
pods assigned to the analyzer, assign labels and channels, and specify
symbols.
At power up, the logic analyzer is configured with a default setting.
You can use this default setting to make a test measurement on the
system under test. It can give you an idea of where to start your
measurement. For an example of setting up configurations for the
Timing analyzer, refer to the Getting Started Guide or "Timing Analyzer
Measurement Example" in chapter 20 of this manual.
HP 16528/1653B
Timing Format Specification Menu
Front-Panel Reference
17-l