Safety Requirements; Instrument Warm-Up; Adjustments; Calibrafion - HP 1652B Getting Started Manual

Hide thumbs Also See for 1652B:

Table of Contents

Specific warnings, cautions, and instructions are placed wherever applicable

throughout the manual. These must be observed during all phases of operation,

service, and repair of the instrument.

Failure to comply with them violates safety

standards of design, manufacture, and intended use of this instrument.

Hewlett-Packard

assumes no liability for the failure of the customer to comply with

these safety requirements.

Requirements

Adjust and calibrate the instrument at it's environmental

ambient temperature

after a 15 minute warm-up.

Unless specified elsewhere, each adjustment procedure must be followed in its

entirety and in the same sequence shown.

The adjustment procedures are performed with the top cover of the instrument

removed. Take care to avoid shorting or damaging internal parts of the instrument.

Read the Safety Summary

at the beginning

of this manual

any adjustment

The calibration procedures in this section should be followed in their entirety and

in the same sequence shown in this section. The steps in each succeeding

procedure assumes that all the previous procedures have been completed in the

proper order.

constants are stored in system memory and not on the Operating

System Disk. Therefore, software calibration is not required when a different

Operating System Disk is used to boot the instrument on power-up.

and Calibration

Service Manual

Chapters

Table of Contents