Using The Analyzer Trigger To Drive The External Analyzer; Figure 5-9. Interactive Measurement Configuration - HP 64700 Series User Manual

Interactive Measurement Specification
BNC <-??-> ---\
CMBT <-??-> ---|
Emulator <---------|
Analyzer ------> --/
NOTES:
1. The connections marked "??" are set up here in configuration.
2. drive = ----> receive = <----
3. The External Analyzer question is only asked when the External Analyzer
mode is state or timing.
STATUS: Interactive Measurement Specification_________________________........
Should BNC drive or receive Trig1? neither
drive receive neither

Figure 5-9. Interactive Measurement Configuration

Note
Using the Analyzer
Trigger to Drive the
External Analyzer
|
| Trig1
Emulator <-??------|
|
Analyzer <-??-> --|
External Analyzer <-??-> --/
(The display won't change, however.)
both
The "External Analyzer" option for Trig2 only appears if you have
selected state or timing for the external analyzer mode.
The analyzer can be used to drive the external analyzer when it
finds its trigger condition. This is done by setting up the analyzer to
drive the trig2 internal trigger and set up the external analyzer to
receive it.
In this configuraton, the analyzer triggers the external analyzer to
start a trace only after it finds its trigger condition. This allows you
to coordinate timing measurements with the occurrence of a
specific analyzer state.
BNC <-??-> ---\
|
CMBT <-??-> ---|
| Trig2
|
|
Using the External Analyzer 5-15
RECALL