Measurementaids - HP 1652B Getting Started Manual

Overlay: Channels
1
and 2 can be overlayed in the same display area.
Connect-the-dots:
straight lines.
Provides a display of the sample points which are connected bY
Waveform Reconstruction: A reconstruction filter fills in the missing data points
when the timebase is set to 5 100 ns/d.ivision or when the timebase setting is
reduced to a point where there are fewer than 500 data samples on the screen.
Waveform Math: Display capability of A-B, B-A, and A + B functions is provided.
Mixed Mode: Oscilloscope plus logic analyzer displays on the same screen.
Measurement
Time Markers: Two vertical markers labeled X and 0. Voltage levels are
Aids
displayed for each marker. Time interval measurements can be made between any
two events.
Automatic Search: Searches for a specified absolute or percentage
a positive or negative edge with count adjustable from 1 to 1024.
voltage level at
Auto Search Statistics: Displays mean, maximum, and minimum values for
elapsed time from X to 0 markers for multiple runs. The number of valid runs
and total number of runs are also displayed.
Trigger Level Marker: A horizontal trigger level marker is displayed in the
Trace/Trigger menu only.
Automatic Measurements: The following pulse parameter measurements can be
performed automatically:
Frequency
Period
v P-P
Rise time
Fall time
Preshoot
Overshoot
+ pulse width
- pulse width
Grid: Selectable (On/Off).
Setup Aids
Autoscale: Automatically sets the vertical and horizontal ranges, offset, and
trigger levels to display the input signals. This requires an amplitude above
10
mV
peak, and a frequency between 50 Hz and 100 MHz.
General Information
1-18
HP
16528/1653B
Service Manual