Connecting The Scope Probes - HP 1652B Getting Started Manual

Go back to the System Configuration menu and turn the Oscilloscope
On as shown below.
I
Syr tom Conf Agurr tion
' Inalyzcr 1
Name : []
Type; []
----------------
(--------_---- 7 )- ____ ;;;; ______ <
Scope On
----------------
Figure
2741.
Re-configure with Scope
Connecting the
Connect the scope probes to the two enable lines that show missing
Scope Probes
signals.
Channel one is connected to LOUTPT.
Channel two is connected to LDISP.
HP
16526/16538
Timing/State/Scope Measurement Example
Front-Panel Reference
27-15