Setting Paper Width; Rs-232C Default Configuration; Recommended Protocol - HP 1652B Getting Started Manual

Setting Paper
Width
Paper width is set by toggling the Paper width : field in the I/O
Port Configuration menu. It tells the printer tha=are sending up to
80 or 132 characters per line (only when you Print All) and is totally
independent of the printer itself.
l
If you select 132 characters per line (13.5 inches) when using
other than an HP QuietJet selection, the listings are printed in a
compressed mode. Compressed mode uses smaller characters to
allow the printer to print more characters in a given width.
l
If you select 132 characters per line (13.5 inches) on an
HP QuietJet, it will print a full 132 characters per line.
l
If you select 80 characters per line for any printer, a maximum of
80 characters are printed per line.
RS=232C
You can use the logic analyzer's default configuration (except for
Default
Configuration
printer type and paper width) for all supported printers if you haven't
changed the printer's RS-232C configuration.
The logic analyzer's default configuration is:
Protocol: XON/XOFF
Data Bits: 8
Stop Bits: 1
Parity: none
Baud rate: 9600
Printer: ThinkJet
Paper width: 8.5 inches
Recommended
The recommended protocol is XON/XOFF. This allows you to use the
_
Protocol
simpler three-wire hook-ups.
Making Hardcopy Prints
7-6
HP 16528/1653B
Front-Panel Reference