HP 1652B Getting Started Manual page 262

15
State Analyzer Measurement Example
Introduction
In this chapter you learn how to use the state analyzer by setting up the
logic analyzer to simulate a simple state measurement. Since you may
not have the same test circuit available, we will give you the
measurement results as actually measured by the logic analyzer,
The exercise in this chapter is organized in a task format. The tasks are
in the same order you will most likely use them once you become
experienced. The steps in this format are both numbered and lettered.
The numbered steps state the step objective. The lettered steps explain
how to accomplish each step objective. There is also an example of
each menu after it has been properly set up.
How you use the steps depends on how much you remember from
chapters 1 through 4 of the Getting started Guide. If you can set up
each menu by just looking at the menu picture, go ahead and do so. If
you need a reminder of what steps to perform, follow the numbered
steps. If you still need more information about "how," use the lettered
steps.
To gain confidence using your logic analyzer, we recommend that you
configure the menus as you follow the simulated measurement example
up to the section "Acquiring the Data." From that section to the end,
you will see the measurement results on the State Listing screen as if
you had the real test circuit connected, and as if you had selected RUN.
.-
HP 16528/l 6538
State Analyzer Measurement Example
15-l