Rs-232-C Interface; Rs-232-C Configuration - HP 1652B Getting Started Manual

6. Touch the SELECT key to enter the new address.
7. Select the DONE field in the upper-right corner of the menu using the
KNOB and SELECT key to exit the External I/O Port Configuration menu.
RS=232-C
Interface
The HP 1652B/1653B interfaces with RS-232-C communication lines through a
standard 25 pin D connector. The HP 1652B/1653B is compatible with RS-232-C
protocol. When a hardwire handshake method is used, the Data Terminal Ready
(DTR) line (pin 20 on the Computer/Modem connector) is used to signal whether
space is available for more data in the logical I/O buffer. Pin outs of the RS-232-C
connectors are listed in table 2-2.
RS-232-C
At
power up, the RS-232-C interface is configured as shown in figure 2-5. To
Configuration
change the RS-232-C configuration:
1.
Press the I/O key on the front-panel keypad and the I/O menu will appear on
screen.
2.
Rotate the KNOB until "I/O Port Configuration" is highlighted.
3. Touch the SELECT key and the External I/O Port Configuration menu will
appear on screen.
AA
External
I/O
Port Configuration
(TKZ-)
Printer connected to [Rs-232-C] Controller connected to IHPIBj
RS-232-C Configuration
Protocol : IXON/XOFF]
Stop Bits : VI
HP18 Configuration
HPIB Address : 171
Parity 1 [ None 1
Baud rate 1 1 9600 1
Data Bits : B
Psinter Inlomation
Printer : lLsserJet] Paper uldth : 18.5"
Figure 2-5. External I/O Port Configuration Menu
4.
Using the KNOB and SELECT key, configure the RS-232-C interface as
desired.
5. Select the DONE field in the upper-right corner of the menu using the
KNOB and SELECT key to exit the External I/O Port Configuration menu.
HP 1652B/1653B
Service Manual
Installation
2-7