Changing Alpha Entries - HP 1652B Getting Started Manual

Figure 3-8. Alpha Entry Pop-up
The top two lines enclosed in boxes in the pop-up contain the complete
alphanumeric set you use for names in these types of fields. The bottom
line (enclosed in brackets) contains the name that existed when you
opened the Alpha Entry pop-up. To enter alpha characters in the
brackets (where the default or old name appears) position the cursor
on the desired character and press SELECT. The new character will be
placed in the brackets where the underscore marker is located. If you
want to place a new character in the brackets at a location not marked
by the underscore marker, move the underscore marker to where you
want the new character to be placed. Moving the underscore marker is
explained in "Changing Alpha Entries."
Note
II 3
You can also make direct keypad entries. Your selection will be placed
where the underscore marker is in the box.
Changing
Alpha Entries
To make changes or corrections in the Alpha Entry field, position the
underscore marker under the character you want to change.
,
To move the underscore marker to the left, place the cursor over the
left arrow and press SELECT once for each backspace.
HP 16528/1653B
Using the Front-Panel User Interface
Front-Panel Reference
3-15