HP 1652B Getting Started Manual page 495

Error Messages
c-2
Configuration not loaded. Indicates a bad configuration file. Try to
reload the file again. If the configuration fde will still not load, a new
disk and/or configuration file is required.
-
Copy operation complete. Indicates the copy operation has either
successfully completed or has been stopped.
Correlation counter overflow. The correlation counter overflows when
the time from when one machine's trigger to the second machine's
trigger exceeds the maximum count. It may be possible to add a
"dummy'+ state to the second machine's trigger specification that is
closer in time to the trigger of the first machine.
Data can not be correlated-Time count need to be turned on. "Count"
must be set to "Time" in both machines to properly correlate the data.
Destination write protected-file not copied. Make sure you are trying to
copy to the correct disk. If so, set the write protect tab to the
non-protect position and repeat the copy operation.
File not copied to disc-check disc. The HP 1652B/1653B does not
support track sparing. If a bad track is found, the disk is considered
bad. If the disk has been formatted elsewhere with track sparing, the
HP 1652B/l653B will only read up to the first spared track.
Hardware ERROR: trace point in count block. Indicates the data from
the last acquisition is not reliable and may have been caused by a
hardware problem. Repeat the data acquisition to verify the condition.
If this message re-appears, the logic analyzer requires the attention of
service personnel.
Insufficient memory to load IAL - load aborted. This message
indicates that there is not a block of free memory large enough for the
inverse assembler you are attempting to load even though there may be
enough memory in several smaller blocks. Try to load the inverse
assembler again. If this load is unsuccessful, load the configuration and
inverse assembler separately.
HP 16528/1653B
Front-Panel Reference