Selecting The Line Voltage - HP 1652B Getting Started Manual

--
Selecting the
Line Voltage
The line voltage selector has been factory set to the line voltage used in
your country. It is a good idea to check the setting of the line voltage
selector so you become familiar with what it looks like. If the setting
needs to be changed, follow the procedure in the next paragraph.
-
Caution
You can damage the logic analyzer if the module is not set to the
correct position.
HP 16528/1653B
Installation, Maintenance and Calibration
Front-Panel Reference
D-7
D-2. Selecting The Line Voltage
You change the proper line voltage by pulling the fuse module out and
reinserting it with the proper arrows aligned. To remove the fuse
module, carefully pry at the top center of the module (as shown) until
you can grasp and pull it out by hand.