Connecting The Grabbers To The Probes; Connecting The Grabbers To The Test Points - HP 1652B Getting Started Manual

Connecting the
Connect the grabbers to the probes by slipping the connector at the
Grabbers to the
end of the probe onto the recessed pin located in the side of the
Probes
grabber. If you need to use grabbers for either the pod or the probe
grounds, connect the grabbers to the ground leads in the same manner.
Figure
2-Q.
Connecting Grabbers to Probes
Connecting the
The grabbers have a hook that fits around the IC pins and component
Grabbers t6 the
leads. Connect the grabber to the test point by pushing the rear of the
Test Points
grabber to expose the hook. Hook the lead and release your thumb as
shown below.
Probing
HP
1652B/16536
2-12
Front-Panel Reference
Figure 2-10. Connecting Grabbers to Test Points
--