Autoload - HP 1652B Getting Started Manual

When you Execute the Store operation, the message "Storing
configuration to disk" appears at the top of the display. After the file
has been stored, the message is replaced with "Store operation
complete" and the file name appears in the bottom section of the Disk
Operations menu with its file type and a description, if you gave it one.
-
Birc ap8r8 u888
CDOM)
1
Store 1 to file -1
File dascrlptton
[TIflING STCITE
nIXED OISPIAVS 1 (S)
Figure 5-4. Store Operation
Autoload
The Autoload operation allows a specified configuration file to be
loaded at power up. When you select Autoload, the top section of the
Disk Operations menu looks similar to that shown below. A field
appears next to the operation field. When you select this field, a
pop-up menu appears with the choices Enable and Disable . Enable
causes the specified file to be automatically loaded at power up.
Disable prevents any fde from being loaded at power up.
Figure 5-5. Autoload Operation
The file name in the file field can be changed with one of two methods.
One method is to press the up/down ROLL key and rotate the KNOB
to scroll through the list of files until the name of the desired file
appears in the file field. The other method is to select the file field and
use the Alpha Entry pop-up menu and the front-panel keypad to enter
the name.
Below the operations and file fields are two information lines. The first
line indicates the status of autoload ( Enable or Disable ), and the
second line tells you which file, if any, is enabled for autoload. When
you select either Enable or Disable the autoload status of a file will not
change until you select Execute.
When you select Execute, after selecting Enable, the file whose name
appears in the f2e field is selected for autoloading. The autoload status
line will say Enable, and the autoload file line will state the name of the
file .
I/O Menu
5-6