Displaying Timing Waveforms - HP 1652B Getting Started Manual

Displaying Timing Waveforms
After the oscilloscope has been armed by the timing analyzer, the pods
can be assigned and accompanying waveforms displayed in the
oscilloscope waveform display. To setup mixed mode display in the
oscilloscope waveforms display, follow the steps below:
1.
From the waveforms display menu, select a channel label.
Remember that the inserted waveform will be placed directly
below the label you choose.
2. From the waveform selection pop-up shown in figure 26-5, select
Insert waveform field.
Waveform selection V-b
POP-UP
-Scope- mvef bms
( Autoscale )
(Aulo-tlessure)
markers I Off
1 Display [ Normal ] Connect dotsl]
Sample period = 100.0 ns
6/ClV ipYEGq
Delay [ 0 s ] Grid piiF]
.
CH
1
,
2.5c v
Insert waveform
I
Llevelom on
nodlfy wavef arm
Wavelom -of I
.
Delete woveform
HP 1652Bl53B
Front-Panel Reference
Figure 26-5. Waveform Label Pop-up
3. Since the timing analyzer machine is arming the oscilloscope,
another pop-up will appear as shown in figure 26-6 that gives you
a choice of Scope or Timing. Select Timing.
Mixed Mode Displays
26-5